Fraud Blocker Skip to content
Free Shipping on Radios · Price Match Most Competitors
Free Shipping on Radios · Price Match Most Competitors

RM Italy KL203P Linear Amplifier with Receive Preamp

Sold out
Original price $97.95 - Original price $97.95
Original price
$97.95
$97.95 - $97.95
Current price $97.95

The RM Italy KL203P is a compact 12V linear amplifier with a manufacturer-rated output of 100W. It combines low-drive operation with a switchable 26dB receive preamplifier and front-panel switches for amplifier power, receive preamplification and AM/SSB selection.

Key features

  • Manufacturer-rated output: 100W.
  • Low-drive input: 0.5–10W, with a 10W maximum from the driving radio.
  • Switchable receive preamplifier: 26dB gain with electronic switching, controlled independently from the front panel.
  • Electronic transmit/receive switching: VOX RTX switching specified by RM Italy.
  • DC operation: Requires a 12–14V DC supply, with maximum current draw of 10A.
  • Compact heatsink housing: Approximately 4.92 × 4.72 × 1.57 inches.
  • Protection and indication: Protection against reversed supply polarity, a 12A fast-blow fuse and front-panel status indication for the amplifier and preamplifier.

Specifications

Specification Manufacturer rating
Model RM Italy KL203P
Product type Linear RF amplifier
Frequency range 28–29.7 MHz
Supported modes AM, FM and SSB
Output power 100W
Input power 0.5–10W
Supply voltage 12–14V DC
Maximum current 10A
Receive preamplifier 26dB, switchable
Transmit/receive switching VOX RTX
Input VSWR 1.1–1.5:1
Fuse 12A fast-blow, approximately 0.197 × 0.787 inches
Dimensions Approximately 4.92 inches long × 4.72 inches wide × 1.57 inches high
Unit weight Approximately 1.05 lb

Setup requirements

Check the driving radio's output before connecting the amplifier. Stay within the manufacturer's 10W maximum input; this is not a high-drive amplifier. Use suitable DC wiring, correct polarity and a properly matched antenna system for the operating frequency.

Keep the heatsink unobstructed and allow adequate ventilation. Do not transmit without a suitable antenna or dummy load connected, and never substitute a higher-rated fuse. Keep power wiring shorter than 118 inches and use 16 AWG or heavier wire, following RM Italy's wiring guidance. If installed in a vehicle, the vehicle must be stationary before use.

US operating restriction

External RF power amplifiers must not be used to increase the transmitting power of a US CB Radio Service station. The KL203P is not a legal CB power upgrade. Observe all applicable equipment-authorization and operating requirements.

Handling time: 3–5 business days.

Frequently asked questions

Is the KL203P a radio?

No. The KL203P is an external linear RF amplifier. It does not replace a transceiver or operate as a standalone radio.

What output power does RM Italy specify?

RM Italy specifies 100W output. The manufacturer publishes a single output figure for the KL203P rather than separate ratings for each mode.

How much input power does it require?

The specified drive range is 0.5–10W. Keep the driving radio at or below the 10W maximum.

Does it include a receive preamplifier?

Yes. The KL203P has a switchable 26dB receive preamplifier with electronic switching, operated by a front-panel control.

What is the difference between the KL203P and the KL203?

The KL203P adds the switchable 26dB receive preamplifier. RM Italy publishes the same frequency range, input power and output power for both models.

What power supply does it need?

The manufacturer specifies 12–14V DC and a maximum current draw of 10A. Use an appropriate DC supply and correctly rated wiring.

Can I use it to increase a CB radio's transmitting power in the United States?

No. US CB Radio Service rules prohibit using an external RF power amplifier to increase a CB station's transmitting power.

How large is the KL203P?

Converted from RM Italy's specifications, the unit measures approximately 4.92 inches long, 4.72 inches wide and 1.57 inches high, and weighs approximately 1.05 lb.

*These units are for industrial, scientific, medical, or export use only. It is a violation of US FCC regulations to operate these units on the Citizens Band or Amateur Radio Services in the United States. Please check regulations in your country before operating these unit.

Compare products

{"one"=>"Select 2 or 3 items to compare", "other"=>"{{ count }} of 3 items selected"}

Select first item to compare

Select second item to compare

Select third item to compare

Compare