A complete over-the-road 10 meter install kit: the Connex 3300HP AM/FM/PA mobile amateur radio, the Stryker SR-A10 10 meter mobile antenna, the DRX-3402 heavy-duty mirror mount, and 18 feet of DRX-1518 premium M213 super-flex coax. Everything you need to put a clean, low-SWR 10m mobile AM/FM setup on the air.

Why this combo

The 3300HP is an easy radio to install — 7 amp current draw, standard 12V DC, front-panel mic jack, small footprint. But it's only as good as its antenna. This kit pairs the 3300HP with a 10m-tuned Stryker antenna on a heavy-duty mirror mount, using premium M213 coax rated well above the radio's output. Everything matched for a clean install and a solid signal without wasted RF or hot coax.

Connex 3300HP — 10 Meter Mobile Amateur Radio

• AM / FM / PA modes (no SSB, no CW, no clarifier)
• 45W PEP AM (Bird), 30W RMS (Dosy) stock output
• Dual MOSFET finals
• 6-band coverage across 28.015 – 28.465 MHz
• Front-panel 4-pin microphone jack
• Blue LED channel display, 3-level dimmer
• Echo board with 2 controls, switchable talkback
• +10 kHz switch, NB/ANL, Hi/Lo power
• Includes Ranger SRA-198 4-pin noise-canceling microphone
• SO-239 antenna connector · ~7A on transmit · 10A fuse
• Dimensions: 11.25" L × 7.875" W × 2.375" H
• 1-year factory warranty through Connex

Stryker SR-A10 — 10 Meter Mobile Antenna

• Purpose-built for 10 meter operation — 12-band coverage tuned to match the 3300HP's frequency range
• Fiberglass shaft with brass tunable tip
• Power handling: 3,000 watts (far above the 3300HP's peak — huge headroom)
• SO-239 base connector
• 2-year Stryker guarantee

DRX-3402 — Heavy-Duty Mirror Mount

• Double-slotted design for use on tractor mirrors, sport bars, and heavy-duty bracketry
• 3/8" × 24 threading (fits the SR-A10 and most 10m mobile antennas)
• Chromed steel construction — corrosion-resistant for over-the-road duty
• Includes hardware for installation

DRX-1518 — 18 ft Premium M213 Super-Flex Coax

• 18 ft length — right-sized for a mirror-mount to under-dash run in most trucks and full-size pickups
• Premium M213 double-shielded construction — low loss at 10m frequencies
• Super-flex jacket handles routing bends without kinking
• PL-259 connectors on both ends (matches the 3300HP and SR-A10 antenna base)

Install and tuning

Antenna installation is where the whole system either sings or squawks. Every antenna needs to be SWR-checked at install — mounting location, ground plane, and coax routing all affect the match. We verify SWR at antenna installation on any local install; if you're installing yourself, an inline SWR meter or an antenna analyzer is essential. Don't transmit at high power into an unverified antenna system.

Coax should be routed away from ignition wiring, spark plugs, and alternator leads. Ground the antenna mount to bare vehicle metal for best radiation efficiency.

10 meter licensing

The 10 meter amateur band requires an FCC amateur radio license (Technician class or higher). See our 10 meter radio license guide for FCC and ARRL testing resources.

Buy the components separately

Each item in this combo is also sold as a standalone product. Buy individually if you already have some of the pieces:

• Connex 3300HP 10 meter amateur radio
• Stryker SR-A10 CB / 10-meter antenna
• Driver Extreme DRX-3402 heavy-duty mirror mount
• Driver Extreme DRX-1518 18 ft M213 premium coax

Don't forget to add the Pro tune and alignment option at checkout so that your radio is professionally bench-tuned for best performance per the manufacturer's service manual.