Stryker SR-955HPC+ 10 Meter Radio + SR-A10 Antenna Install Kit for Truckers — With Mirror Mount & Premium Coax

What's in this combo: Stryker SR-955HPC+ 10 Meter Radio + Stryker SR-A10 Antenna + DRX-3402 Heavy-Duty Mirror Mount + DRX-1518 18-Foot M213 Premium Coax. Everything you need for a full mobile 10-meter install with SSB, minus the mic and speaker.

Who This Combo Is For

This is the complete antenna install kit for operators putting a permanent SSB-capable 10-meter setup on a semi truck, pickup, or heavy-duty work vehicle. If you've already got a mic and speaker you're happy with — or you're building your kit piece by piece — this combo covers the radio and the entire RF chain from radio to antenna. Owner-operators, over-the-road drivers, and fleet mechanics running Peterbilt, Kenworth, Freightliner, Volvo, Mack, and International trucks with west-coast or standard mirror brackets can mount it on a driver-side or passenger-side mirror bracket; measure first.

Already have an antenna install and just need audio? Check out our SR-955HPC+ combo with DRX-9010 speaker and DRX-6560 noise-cancelling mic instead.

Why We Picked These Four Products

• The Stryker SR-955HPC+ is Stryker's flagship 100-watt PEP 10-meter radio with AM, FM, and SSB (LSB/USB). Its SSB is the reason most buyers pick it, dual front-mounted digital echo controls sharpen your voice, and CTCSS/DCS lets you run private-tone. Its 7-1/8-inch depth and Single Sideband capability distinguish this model; measure the intended mounting location and cable clearance before installation.
• The Stryker SR-A10 antenna is modeled after the U.S. Air Force's Thunderbolt II — 6-gauge solid copper coated in 100% silver plate, capable of handling 10,000 watts. Overbuilt for your 100-watt radio, which means it runs cool, efficient, and forever. Reduces static interference and comes with a 2-year warranty.
• The DRX-3402 mirror mount is built from .250″ aircraft-quality extruded aluminum with a 2.50″ wide double-slotted design. The SR-A10 is a big, heavy antenna — this is the mount that won't flex or fatigue holding it up over a million highway miles. Stainless-steel Square-Lock hardware means one-wrench install and no lost washers.
• The DRX-1518 18-foot M213 coax is ultra-low-loss double-shielded cable that delivers RG213-grade performance in a mobile-friendly diameter. 96% tinned copper braid plus 100% aluminum foil shield means your 100 watts get from the radio to the antenna, not radiated into your cab wiring — critical for clean SSB transmission.

Buying these four separately, you'd have to match antenna power handling to radio output, verify the coax connector types, confirm the mount slot spacing fits the antenna stud, and work out cable length for your cab-to-mirror run. We've matched the parts; measure your mounting locations and coax run before ordering.

What's Included

10 Meter Radio

• Part Number: Stryker SR-955HPC+
• What It Does: 100W PEP · AM/FM/SSB · CTCSS/DCS · dual echo · PC programmable

Mobile Antenna

• Part Number: Stryker SR-A10
• What It Does: Silver-plated 6-gauge copper, 10,000W handling, 49″ SS whip

Mirror Mount

• Part Number: DRX-3402
• What It Does: .250″ aircraft aluminum, double-slotted, DX239 stud

Coax Cable

• Part Number: DRX-1518
• What It Does: 18 ft. M213 Quantum-Flex, 50Ω, double-shielded, ultra-low loss

Stryker SR-955HPC+ 10 Meter Radio

The Stryker SR-955HPC+ is a 100-watt PEP AM/FM/SSB 10-meter amateur radio and the newest member of the Stryker family. Its Single Sideband capability is what sets it apart — critical for DX chasing and long-haul contacts where the difference between usable and garbled audio comes down to how well the radio holds frequency. Dual front-mounted digital echo controls let you dial voice clarity to exactly the level you want, and variable talkback eliminates the squeal that plagues cheaper radios. The case measures 7.125″ deep × 7.875″ wide × 2.375″ tall. Measure your mounting space and allow extra clearance for cables, connectors and ventilation.

Key features: 100W PEP · AM/FM/SSB/WX/PA modes · Single Sideband (USB/LSB) · Dual front-mounted digital echo controls · Variable Power Output Control · Variable Talkback Circuit with on/off switch · CTCSS/DCS codes · Auto-calibrating SWR · Six-band operation · VFO Mode · Selectable eight-color display · 32-position variable dimmer control · Automatic Noise Limiter · Six Roger Beeps · Oversized meter for Power/Modulation/SWR/Signal · PC programmable via included USB programming cable · 7.875″ W × 2.375″ H × 7.125″ D.

Stryker SR-A10 10 Meter Antenna — The "Thunderbolt II"

The Stryker SR-A10 is modeled after the antenna profile on the U.S. Air Force's Fairchild Thunderbolt II. Engineered for maximum efficiency and durability at high power, it's overbuilt for the SR-955HPC+'s 100 watts — which means it runs cool, keeps clean signal, and lasts through years of highway abuse. Silver-plated 6-gauge copper coil and stainless-steel whip stand up to rain, road salt, and truck-wash detergents.

Key features: Modeled after the U.S.A.F. Thunderbolt II · 6-gauge solid copper · 100% silver-plate coating · 10,000W power handling · Extremely efficient high-Q coil · Double-wall coil cover in high-impact Mobay plastic · 10″ & 20″ stainless steel shafts · 49″ stainless steel whip · Reduced static interference · 2-year warranty. Sold in bulk — no retail packaging.

DRX-3402 Heavy-Duty Antenna Mirror Mount

The DRX-3402 is a Driver Extreme heavy-duty mount purpose-built for large mobile antennas like the SR-A10. Extra-large 2.50″ wide mount from .250″ aircraft-quality extruded aluminum, with Driver Extreme's exclusive Square-Lock hardware for one-wrench installation. The double-slotted design gives you fitment flexibility across west-coast, standard, and heavy-duty pickup mirror brackets.

Key features: Extra-large 2.50″ wide mount · .250″ thick aircraft-quality extruded aluminum · Driver Extreme Square-Lock hardware · Stainless steel carriage bolts with extended square shank (one-wrench install) · Stainless steel K-Lock nuts with encapsulated lock washers · Proprietary DX239 heavy-duty stud · Stainless steel center stud inside a 1″ plated aluminum hex base · Threaded stainless female nut encased in ABS plastic.

DRX-1518 18-Foot M213 Premium Coax Cable

The DRX-1518 is 18 feet of Driver Extreme M213 Quantum-Flex coax — RG213-grade performance in a mobile-install cable diameter. Ultra-low-loss double shielding means the 100 watts your SR-955HPC+ makes actually get to the antenna instead of getting lost as heat in the cable or radiated as noise into your truck's electronics. Especially important on SSB, where every dB of transmit efficiency matters for long-haul contacts.

Key features: 18-foot length · 50-ohm impedance · Tinned copper braided shield (96% coverage) · Free-floating aluminum foil shield (100% coverage) · Ultra-low signal loss · M213 Quantum-Flex double-shielded construction · Mobile-friendly diameter.

Installation Overview

A typical mobile install on a semi truck runs like this:

1. Mount the DRX-3402 to the driver-side or passenger-side mirror bracket using the double-slotted alignment.
2. Attach the SR-A10 antenna to the DX239 stud on the mount. Torque per manufacturer spec.
3. Route the DRX-1518 coax from the mount, down through the cab body, and into your radio location. Avoid running parallel to power wiring — cross at 90° where possible.
4. Connect the coax's PL-259 connector to the SR-955HPC+'s SO-239 antenna jack.
5. Use the SR-955HPC+'s built-in auto-calibrating SWR meter to check the install. Adjust the SR-A10's whip length up or down as needed to bring SWR under 1.5:1 on your primary channel.

The SR-955HPC+'s built-in SWR meter means you don't need a separate meter or bench visit to dial the antenna in, so you can tune the install yourself.

Frequently Asked Questions

What's included in this Stryker SR-955HPC+ install combo?
This combo includes four products: the Stryker SR-955HPC+ 100-watt AM/FM/SSB 10-meter amateur radio, the Stryker SR-A10 silver-plated mobile antenna, the DRX-3402 heavy-duty mirror mount, and the DRX-1518 18-foot M213 Quantum-Flex coax cable. Everything you need to complete a mobile antenna install, minus the microphone and external speaker.

How is the SR-955HPC+ different from the SR-655HPC+?
The SR-955HPC+ adds Single Sideband (SSB), dual front-mounted digital echo controls, CTCSS/DCS codes, and six-band operation with VFO mode. If you only run AM/FM local traffic, the 655 kit is a great choice. If you want SSB for DX chasing or long-haul contacts on the 10-meter band, the 955 is the upgrade — Single Sideband capability and a 7-1/8-inch-deep chassis.

Is the Stryker SR-A10 a good antenna for the SR-955HPC+?
Yes — the SR-A10 is our top recommendation for the SR-955HPC+ specifically. It's rated for 10,000 watts, so at the SR-955HPC+'s 100-watt output the antenna is running at 1% of its capacity — it stays cool, efficient, and delivers years of reliable transmission. The silver-plated 6-gauge copper coil is one of the most conductive antenna designs available for the 10-meter band, and the low static profile matters for SSB reception.

Will the DRX-3402 mount fit my truck's mirror bracket? Measure first. The DRX-3402 is a 2.50″ wide, .250″ thick mirror mount made for semi trucks and large trucker-style antennas. Bracket designs vary, so check yours before ordering, or contact us with your make and model.

Why is the DRX-1518 coax 18 feet — is that long enough?
For many truck cab installs, 18 feet is enough to route from a mirror-mounted antenna down through the cab body and to a radio mounted in the dash or overhead console, with a service loop for door movement. Measure your planned run first. If you're running a sleeper cab install with the radio in the bunk area, you may need a longer cable. Contact us if you need a custom length.

What SWR should I expect after installing this combo?
After proper installation and adjustment, you should see SWR of 1.5:1 or better across your primary operating range on the 10-meter band. The SR-A10's whip is adjustable — trim it slightly for higher-frequency operation or lengthen it for lower. The SR-955HPC+'s built-in auto-calibrating SWR meter lets you tune the install without a separate meter.

Can I add a microphone and speaker to this combo?
Yes. Many truckers pair this install combo with our DRX-6560 noise-cancelling dynamic microphone and DRX-9010 external speaker for a complete cab audio upgrade. If you want everything in one package instead, see our SR-955HPC+ combo with speaker and mic.

Does the SR-955HPC+ work as a CB radio? No. The SR-955HPC+ is a 10 meter amateur radio for the 28.000-29.700 MHz band, not the 27 MHz Citizens Band. An FCC amateur radio license is required to transmit, with General class or higher required for its full 28.000-29.700 MHz range. Receive-only monitoring does not require a license.

Do I need any additional parts to complete the install?
This combo includes the radio, antenna, mount, and coax. The SR-955HPC+ comes with a stock 4-pin dynamic microphone, power cord, mounting bracket, and mic clip — so you can transmit right out of the box. Depending on your specific install, you may also want: an upgraded microphone (the DRX-6560 is our recommendation for cab noise), and an external speaker (the DRX-9010 is our top pick for trucks).

How much power supply do I need for a base station install of this combo?
The SR-955HPC+ is rated 12 A with modulation on AM, and current draw peaks higher on SSB, so you'll want a regulated DC power supply rated for at least 25–30 amps continuous for a home base install. For a truck install, wire directly to the battery through a properly-rated fuse — do not run it off the accessory circuit at full power.

Can I use this combo as a base station setup?
The SR-955HPC+ and DRX-1518 coax work fine in a base station configuration. However, the SR-A10 and DRX-3402 mirror mount are designed for mobile use. For a base install, you'd want a 10-meter vertical antenna or dipole cut for 28 MHz instead. Contact us if you want to build a base station combo and we'll recommend the right antenna and mount for your location.

Where to Buy the Stryker SR-955HPC+ Antenna Install Combo

At CB Radio Supply, we've been putting together 10-meter install combos for professional drivers and owner-operators for years. The antenna's power handling matches the radio's output and the mount fits the antenna stud. If you're building a mobile SSB-capable 10-meter setup on a truck, this is the install kit we recommend. Contact us if you have questions about fitment for your specific truck or need a custom coax length.

Don't forget to add the Pro tune and alignment option at checkout so that your radio is professionally bench-tuned for best performance per the manufacturer's service manual.

• Price match: We price match most competitors. Contact us with the competing offer.
• Warranty: 3-year Stryker manufacturer warranty on the radio; 2-year Stryker guarantee on the SR-A10.
• Returns: Return requests accepted within 30 days, subject to our return policy.