A complete over-the-road 10 meter install kit: the Ranger RCI-99N2 200W+ PEP mobile amateur radio, the Stryker SR-A10 10 meter mobile antenna, the DRX-3402 heavy-duty mirror mount, and 18 feet of DRX-1518 premium M213 super-flex coax. The AMP ON/OFF switch selects whether the internal amplifier is engaged; amateur-license requirements apply in either setting. Check and adjust antenna SWR after installation for the intended operating frequency.

Why this combo

This kit pairs the RCI-99N2 with a Stryker SR-A10 antenna, heavy-duty mirror mount and 18-foot coax cable. Antenna matching depends on the installation and operating frequency; verify SWR before transmitting.

Ranger RCI-99N2 — 10 meter mobile amateur radio

• AM / USB / LSB / PA modes (no FM, no CW)
• 200W+ PEP AM/SSB output with the amplifier engaged
• Factory AMP ON/OFF switch enables or disables the internal amplifier deck
• Adjustable AM carrier: approximately 0.5–5W with amp off or 10–50W with amp on; AM carrier and PEP are different measurements
• Variable RF power output
• 13.8V DC input; use a properly fused direct-to-battery vehicle connection or a 40A continuous regulated supply for base-station use
• Manufacturer-listed amateur frequency coverage: 28.315–29.660 MHz
• 5-digit LED frequency counter, 7-color selectable backlight, brightness dimmer
• Built-in auto-calibrating SWR meter with high-SWR warning light
• Heavy-duty amplifier heat sink; allow ventilation space around the radio
• Fine clarifier (RX only, ±1.0 kHz); does not change the transmit frequency or frequency-counter display
• Includes Ranger SRA-198NC 4-pin chrome noise-canceling microphone
• Radio dimensions: 7⅞" W × 11⅛" D × 3¼" H (manufacturer-listed dimensions)
• Factory warranty support through Ranger USA

Stryker SR-A10 — 10 Meter Mobile Antenna

• CB/10-meter antenna tunable for 26–30 MHz; adjust and verify SWR for the intended operating frequency after installation
• Stainless-steel shaft and 49-inch stainless-steel whip
• Air-wound 6-gauge solid copper coil with silver plating
• Manufacturer-advertised power-handling capability: 10,000 watts
• Standard 3/8-24 threaded shaft attaches to the antenna mount stud
• 2-year Stryker warranty

DRX-3402 — Heavy-Duty Mirror Mount

• Heavy-duty double-groove mirror mount; verify fit with your vehicle’s mounting location
• Aircraft-quality extruded aluminum bracket, 2.50 inches wide and 0.250 inches thick
• Includes the DX239 heavy-duty antenna stud with 3/8-24 antenna attachment and SO-239 coax connection
• Stainless-steel Square-Lock carriage bolts and K-Lock nuts for installation

DRX-1518 — 18 ft. Premium M213 Super-Flex Coax

• 18-foot, 50-ohm M213 Quantum-Flex coax cable; measure your required routing length before installation
• Double shielding: 96% tinned-copper braid over 100% free-floating aluminum foil
• Flexible cable construction for routing; avoid sharp bends, pinching and kinks
• DX259 two-piece male UHF connector design allows routing through a 12 mm hole
• Connects the radio’s antenna socket to the mount’s DX239 stud; the SR-A10 threads onto the stud rather than connecting directly to the coax

Install and tuning

Antenna installation is where the whole system either sings or squawks. Every antenna needs to be SWR-checked at install — mounting location, ground plane, and coax routing all affect the match. We verify SWR at antenna installation on any local install; if you're installing yourself, an inline SWR meter or an antenna analyzer is essential. Don't transmit at high power into an unverified antenna system.

Coax should be routed away from ignition wiring, spark plugs, and alternator leads. Ground the antenna mount to bare vehicle metal for best radiation efficiency.

10 meter licensing

Operating this amateur radio requires an FCC amateur radio license. Frequency, mode and power privileges depend on license class; the AMP ON/OFF setting does not change those requirements or make this a CB radio. See our 10 meter radio license guide before operating.

Buy the components separately

Each item in this combo is also sold as a standalone product. Buy individually if you already have some of the pieces:

• Ranger RCI-99N2 200 watt SSB/AM 10 meter amateur transceiver
• Stryker SR-A10 CB / 10-meter antenna
• Driver Extreme DRX-3402 heavy-duty mirror mount
• Driver Extreme DRX-1518 18 ft M213 premium coax

Don't forget to add the Pro tune and alignment option at checkout so that your radio is professionally bench-tuned for best performance per the manufacturer's service manual.